Professional set Waterproof (for glass) 1000 ml, GAT

Professional nanocoating for glass, providing better visibility and thus increased traffic safety.
Glass for a long time become water-repellent properties, it is easier to clean and easier defrosted. Under the influence of the oncoming air flow while driving, car glass self-cleaning. Does not contain silicone, wax, etc.
The duration of 12 months or 20,000 kilometers.

Advantages of NANO:

A clear improvement of visibility in bad weather conditions - rain, snow, etc.;
 Increased safety - significantly reduces glare from headlights of oncoming cars;
Resistance 6 times the durability of other products on the market. In the backing there is no silicone or wax.
Increase speed of response – at a speed of 100 km/h the braking distance is reduced by 28 m;
Ice, frost and insect remains can be easily removed;
Increases the service life of the wiper;
Wax washing systems and additives in the washers not harm the coated surfaces.

Set of equipment:

 1 bottle nanocomponent K1, 500 ml;
1 bottle nanocomponent K2, 500 ml;
1 bottle of cleaner-milk for pre-cleaning glass, 1000 ml;

One package is enough to cover nanosustain all glass 60-80 cars.

Instructions for use:

STEP 1: clean the glass

The glass should be thoroughly cleaned of adhering dirt and insects.
After a preliminary cleaning, use a cleanser that before applying you must shake well. Apply lotion evenly on the entire surface of the glass with paper napkins. When applied to the surface ensure that the milk is formed on the surface of the white uniform emulsion, not trickled down. If not, the process of applying the cleansing milk you need to repeat. Such effect is possible on the surface, which is poorly cleared of residual wax, silicone or other protective compounds.
After applying cleansing milk you need to wait until it is completely dry on the surface. After drying, remove the resulting white residue with a clean cloth. Do not fear getting the white jelly on plastic or rubber parts – whitish Deposit can be easily removed with water.

STEP 2: Applying the composition

Pour the contents of the vial into the vial K2 with a composition K1. Close the cap tightly.
Please note! Mix only the amount of the composition that you plan to use within 24 hours (otherwise the remains will lose their properties!)
Shake vigorously the vial with the solution for 2 minutes.
Cut off the tip of the cap of the bottle with the obtained solution. Using a clean paper cloth apply solution to glass in a circular motion. The solution should be applied with a force successively covering small areas.
After 1-2 minutes, using a clean napkin, carefully Polish the surface until the disappearance of visible opaque or whitish areas.
If the surface in some places, again covered with a matte, barely visible whitish patina, buff it one more time, pre-treating this phase rastvorom dampened cloth.
The machined surface should not be subjected to mechanical or chemical attack for at least 30 minutes.

General guidelines
Important! For best result, the surface treatment must be carried out at moderate temperatures (15-25°C) and humidity above 60%. Avoid direct sunlight, rain, low temperatures, snow and dirt. The surface must be completely dry. If the surface is heated, wait until it cools.
Caution: Keep out of reach of children. In case of contact with eyes rinse immediately with plenty of water. Flammable. Work away from possible sources of open flame and working the ignition system. No Smoking. If swallowed, you should immediately consult a doctor. Inhaled vapors may cause drowsiness. After use, tightly close the bottle.
Protective composition the GAT is a 2-component. Components can be stored for at least 1 year without losing its properties. The resulting solution of the mixed components can be stored for more than 24 hours.
The result of processing nanosustain (NANO) is a very long-term. After the time to renew the protective properties of the surface can be processed again.
Note: the Use of different types of ice or cleaning fluid in the washer system is not limited.

Production: Germany
Brand: GAT

Item weight: 2 kg

Scope of application: for glass